Crimestopper Security Products CS-882 - Manual (Page 4)

WIRING
GREEN WIRE: (-) HOOD/TRUNK TRIGGER
Connect this wire to a grounding hood / trunk pin switch or to existing factory hood and trunk pin switches that read
ground when open. If no existing switches are available, new pin switches may be installed. Note: DO NOT mount
new pin switches in water pathways.
RED/WHITE: (+/-) Door Unlock Validation Signal INPUT: [Default Setting is Negative]
Connect to Vehicle’s Door Unlock Switch wire. NOTE: The module must be programmed for the correct signal polarity.
(Flipping switch on top of control module will change the input polarity.) This wire prevents system from being defeated
simply by pressing the vehicle’s unlock button at the door panel when triggered.
GREEN/WHITE: (+/-) Door Lock Validation Signal INPUT: [Default setting is Negative]
Connect to Vehicle’s Door Lock Switch wire. NOTE: The module must be programmed for the correct signal polarity.
(Flipping switch on top of control module will change the input polarity.) Prevents system from being armed when
manually pressing the vehicle’s Lock button at the door panel.
BLUE/BLACK: Door Unlock Signal INPUT:
Connect to Vehicle’s (+12V) Door Unlock (Solenoid/Motor) Wire.
YELLOW/BLACK: Door Lock Signal INPUT:
Connect to Vehicle’s (+12V) Door Lock (Solenoid/Motor) Wire.
**SEE DOOR LOCK MOTOR / VALIDATION WIR E CONNECTIONS NEXT PAGE
WIRING: MINI PLUGS
2-PIN PLUG (WHITE): PROGRAM/VALET BUTTON Connects to white plug on module.
2-PIN PLUG (RED): LED INDICATOR (RED FLASHING LIGHT) Connects to red plug on module.
3 PIN SENSOR PLUG:
WHITE Wire: Negative Signal
BLACK Wire: Sensor Ground
RED Wire Sensor +12V Power
SHOCK SENSOR: The sensor supplied with
this system does not require any additional
wiring. Simply mount the sensor in a suitable
location, plug it in, and adjust the sensitivity.