Whirlpool 900 Series - Manual (Page 13)

SETTING THE CONTROLS
CYCLE
A shows what each cycle includes
CYCLE
TIME
(Minutes) WASH RINSE
MAIN
WASH RINSE
FINAL
RINSE DRY
RINSE-WASH LATER
• Do not use detergent.
• The water heats to 140°F (60°C) in
the final rinse (marked’').
• AIR DRY is automatically selected.
• •t
16*
* Cycle time includes dry time and may be longer depending on the temperature of water entering the dishwasher. The cooler the water, the
longer the cycle time. If the water is already hot enough, the cycle times will be as shown. The Cycle Control Knob does not move while water is
being heated.
Canceling a cycle
You can cancel a cycle at any time.
1. Turn the Cycle Control Knob slowly
clockwise until you hear water draining.
Let the dishwasher drain completely.
2. Open the door.
3. Turn the Cycle Control Knob to OFF.
Selecting cycle options
If desired, press one or more Option pad(s).
You can press an Option pad after the
dishwasher starts as long as the cycle has not
passed the point that the option is used. For
example, you can press AIR DRY any time
before the Cycle Control Knob reaches DRY.
HI-TEMP WASH
When HI-TEMP WASH is selected, the
dishwasher heats the water
during the main wash of the
LIGHT and NORMAL cycles.
Heating the water helps improve
washing results. The POTS-N-
PANS cycle automatically uses
HI-TEMP WASH.
AIR DRY
When AIR DRY is selected, the air in the
dishwasher is not heated during
the “dry” portion of a cycle. Using
AIR DRY helps save energy, but
dishes take longer to dry and
some spotting can occur. Some
(such as plastics) may need towel
For best drying, use a liquid rinse
DRY
□
WASH
□
items
drying
agent.
NOTE: The dishwasher automatically
heats the air in the dishwasher during the
“dry” portion of the cycle unless you select
AIR DRY. AIR DRY is automatically selected
for the RINSE-WASH LATER cycle.
NOTE: The Cycle Control Knob does not
move while water is being heated. Once the
water reaches the proper temperature, the
Cycle Control Knob will begin moving again.
13