beautypg.com

Now start, With washer in laundry area, Pull the strap completely out of the washer – Whirlpool 3358968 User Manual

Page 3: A caution

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Now start...

With washer in laundry area.

Pull the strap

completely out of

the washer.

I

■ Pull to completely remove the

shipping strop with 2 cotter pins from the
Inside of the washer,

shipping strap from the back of the
washer. The shipping strap plug must be
completely removed from the washer for
the self-leveling legs fo be released,
Save the shipping strap for use in Step 17.

^mrn

Read, then remove label that

covers power cord and drain connector,

Peel the tape down and off each side of

cabinet.

Use new hoses and washers that came

with your washer.

3

coupling washer

■ Insert a flat washer into each end

of the inlet hoses. Check that washers are
firmly seated in couplings.

Inlets are plastic.
Do not strip or
crossthread.

Attach hose to bottom inlet valve

opening first; then second hose to top
inlet. Tighten couplings by hand. Then
use pliers to make an additional two-
thirds turn.

IMPORTANT: THIS PROCEDURE MUST BE
FOLLOWED TO ASSURE PROPER
INSTALLATION.

5

To prevent the drain hose from

■ coming off or leaking, it must be

installed per the following instructions:

1. Wet the inside end of the drain hose

with tap water, DO NOT USE ANY
OTHER LUBRICANT.

2, Squeeze ears of clamp with pliers to

open and place clamp over the
end of the drain hose,

3, While holding clamp open, work

end of drain hose onto drain
connector until drain hose is within

1/4 inch (0,64 cm) of ribbed stop,

4, When the end of the drain hose is

within 1 /4 inch (0,64 cm) of ribbed
stop, position clamp on drain hose
so that the bottom of the clamp is

1/4 inch (0.64 cm) from the end of

the hose, release pliers.

0

-

1

/

4

max.

(

0

-

0.64

cm)

Open

clamp and slide
over "hook" end of
drain hose to

secure the rigid
and corrugated
sections together

A CAUTION

Floor Damage

Slide washer onto cardboard or
hardboard before moving across fioor.
Faiiure to do so may cause damage to

floor covering.

■ ■ Move washer close to final

position. Put "hook" end of drain hose
into laundry tub or standpipe. Check for
proper length of drain hose.