Changing the light bulh, Adjusting the refrigerator shelves, To remove the shelf – Whirlpool EL13SC User Manual
Page 6: Removing crisper and crisper cover, To remove the cover, Ice cube trays, Sounds you may hear, Probable causes, Removing crisper and crisper, Cover
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing the light bulh...
WARNING: Before removing a light bulb, either unplug the refrigerator or disconnect the
electricity leading tc the refrigerator at the main power supply. Shock and injury can
cccur if electricity remains connected.
1. Reach behind the control console to find bulb,
2.
Remove bulb.
3.
Replace with a 40-watt appliance bulb.
Adjusting the refrigerator shelves...
GUIDE STOP
To remove the shelf:
1. First, remove food from shelf.
2.
Slide shelf straight out to stop.
3.
Lift front, slide shelf the rest of the way out.
shelf
stop
To replace the shelf:
1. Fit book of shelf on top of guides with wire stops
on the bottom of guides.
2.
Lift front, slide shelf in until it clears guide stops.
SHELF GUIDE
Removing crisper and crisper cover...
To remove the crisper:
• Slide crisper straight out.
To remove the cover;
1. Lift back, then slide to the rear until the front can
be lifted.
2.
Lift cover up and out.
To replace the cover:
1. Slide the front cover tabs into the back of the
front supports on the refrigerator walls.
2.
Lower back into place.
Ice cube trays...
For best results when freezing ice cubes, place
ice cube trays side-by-side in bottom of freezer
compartment.
If cubes are not used, they may shrink. The longer
cubes are stored, the smaller they get.
Lin THE FRONT, THEN THE BACK.
Sounds you may hear...
To remove ice:
1. Flold tray at both ends.
2,
Slightly twist.
\
Possible Sounds:
• Water Sounds:
• Running Sounds:
Your new refrigerator may make sounds that your old one didn't.
Because the sounds are new to you, you might be concerned about them.
Don't be. Most of the new sounds are normal, Flard surfaces like the floor,
walls and oabinets can make the sounds seem louder.
The following chart describes the kinds of sounds that might be new to
you, and what may be making them.
Probable Causes:
When the refrigerator stops running, you may hear gurgling in the
tubing for a few minutes after it stops.
Your refrigerator has a high-efficiency compressor and motor.
It will run longer than older designs. It may even seem to run most
of the time.