Whirlpool EV190E - Manual (Page 6)

Removing the bottom basket...
To remove:
1, Lift front of basket up to rennove from wall supports.
2. Pull out.
To replace:
1, Position basket in bottom of freezer
2 Insert basket into wall supports one side at a time.
Adjusting the freezer shelf...
To remove shelf:
1. Remove food from shelf
2. Slide shelf straight out to stop.
3 Lift front,
4, Slide the rest of the way out
To replace shelf:
1 Fit back of shelf on top of guides with wire stops on
bottom of guides.
2 Lift front, then slide shelf until it clears the guide
stops.
Guide Stop
Shelf Stop
Shelf Guide
The key eject lock...
can help reduce the hazard
entrapment
of child
The signal light...
automatically warns of any unexpected
power failure
Signal Light
If the signal light is not glowing, immediately check:
• for power interruption,
• for an unplugged power cord,
• for a burned out signal light.
Energy saving tips...
You can help your freezer use less electricity
• Check door gasket and level freezer to assure a
good door seal
• Clean the condenser coils regularly
• Keep door openings to a minimum. Remove several
items at one time. Keep contents organized to elimi­
nate searching
• Fill to capacity Follow recommended pror jdures
for freezing foods. See pages 8 and 9,
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
boded so the key cannot be left in the lock
t the key is lost, contact your WHIRLPOOL
dealer for a replacement Always give the com­
plete model and serial number of your freezer
when requesting a replacement key
1. Unplug power cord from outlet
2 Open the freezer door
3, Push out signal light from behind, then unplug
burned out light. Replace light with one of
the same wattage and size. Signal light can
be ordered from your WHIRLPOOL dealer.
Part No, 1103639,
4, Close freezer door and plug power cord into
outlet.
Set Temperature Control to provide temperatures
aroundO F( 17,8 C], There is no need to store
foods below 0 F
Keep door locked to ensure door closure.
Do not let frost build up to more than Ki inch (6 mm)
thick. Efficiency is reduced.
Keep Power Saving Control on OFF when humidity is
low