Other operating instructions, For a rinse and spin, For a soak or pre-wash – Whirlpool LT4905XM User Manual

Page 10: For a drain and spin, Cleaning the lint niter

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Other operating instructions

permanent

press

For a rinse and spin

You may need an extra rinse and

spin tor heavily soiied loads which

need more detergent. (Extra de

tergent can require an extra rinse.)
• Push Controi Knob in.
• Turn clockwise to any *on the diai.

See above drawing.

• Pull Control Knob out.
• The washer will fill to selected level

with cold water, agitate

minutes,

drain and spin.

For agitation and spin speeds

For a soak or pre-wash

For best results, use warm water

for soaking or pre-washing soiled

laundry.

For a drain and spin

Your washer can be set to drain

and spin out water.
• Push Control Knob in.
• Turn ciockwise to the bar just before

OFF. See above drawing.

• Pull Control Knob out.
• The washer will drain and spin.

in each cycle, see pages

and 9.

Use enough detergent or pre-soak
product for a single load.
Push Control Knob in.
Turn clockwise to point at a number
in the SOAK Cycie.
Puil Controi Knob out.
When the cycle Is over, add de

tergent for the next selected wash
cycle. Important: See additional
care intormation on page 7 of your
“Laundry Guide.”

Set the washer and startthenext

selected wash cycle.

To start the soak or pre-wash with agitation, the Cycle Control

Knob must point to a number in the SOAK Cycle.

Cleaning the lint niter

Water runs through the lint filter

whenever the washer agitates.
Check it often to make sure it's clean
and is filtering at its best.

To remove it for cleaning, press the

release and pull straight out. Instruc
tions for Cleaning are printed on the
bottom of the filter.