Whirlpool FGP357Y - Manual (Page 17)

C A R I N G F O R Y O U R R A N G E
Gas must flow freely through the small hole in the
brass orifice for the burner to light properiy. This
area must be free of any soil and be kept
protected from boilovers or spillovers.
ALWAYS
keep the burner caps in place whenever a
surface burner is in use.
After cleaning the gas tube opening, replace
the burner cap and trim ring.
Occasionally check the burner flames for
proper size and shape as shown. A good flame is
blue in color. If flames lift off ports, are yellow, or
are noisy when turned off, you may need to clean
the burners. If ports are clogged, clean with a
straight pin. Do not enlarge or distort port. Do not
use a wooden toothpick. If adjustment is
needed, call a qualified technician for service.
To replace burner cap, make sure cap is
properly aligned and leveled. Find the recessed
locating tabs on the burner cap (see illustration)
and place cap over the white ignitor in the burner
base.
Turn the burner on to determine if it will light. If
the burner does not light after cleaning,
contact
an authorized Roper service technician.
Do not service the sealed burner yourself.
"^^^WwTFFlf^
Typical surface burner flame
Removing the oven door
Removing the oven door will help make it easier
to clean the oven.
^WARNING
Burn and Electrical Shock Hazard
Make sure all controls are OFF and the oven
is cool before removing oven door.
Failure to do so can resuft in burns or
electrical shock.
To remove:
1. Open the door as far as it will go.
2. Remove the screws on each side of the oven
door.
3. Close the door about V4 of the way.
4. Lift the door up and off the hinges.
17