Whirlpool 3ED26MM - Manual (Page 4)

1, Allow A" [,2cm) space on each S'de and at top for
ease of insfallation
2, The refrigerator back can betiusti against the w-ail
3, If the refrigerator is to be in a corner, keepT-i; inches
[3,1 cm) between the wall and s de of the re­
frigerator so there is room to open the SERVA-
DOOR" or to clear the ice and water dispenser.
Level refrigerator-freezer...
1 Remove case grille [see page 10)
2, To raise front, turn eacn screw *o the rig>^’
3 To lower front, turn each screw to tne left
4 Check with level
Remove sales labels...
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue:
1 R ud briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing detergent solution [1
teaspoon detergent in 1 guart warm water) before
removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the
material.
NOTE; DO NOT REMOVE ANY PERMANENT IN­
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean jt...
Clean your refrigerator
before usmg r
See cleaning 'ustruciions
on page 10
Plug it in...
,A
RECOMMENDED GROUNDING METHOD
A 230 Volt, 50 rtz,, AC only, 7,5 ampere fused and
properly grounded electrical supply is required. It is
recommended that a separate circuit serving only
this appiianoe be provided
Do not use an extension cord. Use a recepta­
cle which cannot be turned off with a switch or
pull chain.
See individual eleotrioal requirements
and grounding nstruction sheet in your literature
package.