Whirlpool LLR5144BQ0 - Manual (Page 5)

O P E R A T I N G Y O U R W A S H E R
Operating Your Washer
In This Section
Page Page
Before starting your washer........................ ........... 5 Selecting a cycle and time................... .................6
Starting or stopping your washer................ ........... 5 Using rinse and spin............................ ................ 8
Selecting a load size................................... ........... 5 Using drain and spin............................ ................ 8
Selecting wash-rinse temperatures............. ........... 6 What happens in each cycle................ ................ 9
Operating your washer properly ensures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a sorted NOTE: If your washer has a Consurner
load in the washer before starting. See page 12 Feature Guide, remove it and place it in your
for additional “Before you wash" information. Use and Care Guide.
Starting or stopping your washer
starting your washer:
1. Select a load size and water temperature.
2. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob’s outer ring points to the number (or
mark) in the wash cycle you want. The
numbers are minutes of wash time. Make
other selections, if necessary.
3. Pull out the Cycle Control Knob.
Refer to pages 6-9 for additional information to
help you make selections.
Stopping and restarting your washer:
• To stop the washer at any time, push in the
Cycle Control Knob.
• To restart the washer, close the lid (if neces­
sary) and pull out the Cycle Control Knob.
Cycles may vary with model
Selecting a load size
Position the Load Size Selector at the setting
that corresponds to the size load you want to
wash. Select a load size based upon the size
of the load and the fabric you are washing. See
page 12 for additional loading information.
Settings may vary with model