Whirlpool EC5100XP - Manual (Page 3)

Contents
BEFORE YOU PLUG IT IN ...................... 3
USING YOUR ICE MAKER ...................... 4
Howthe Ice Maker Works.................. 4
Setting the Controls........................ 4
Changing the Bin Door Panel ............. 5
CLEANING AND CARING FOR YOUR
ICE MAKER..................................................... 6
Cleaning Exterior Surfaces................ 6
Cleaning the Condenser................... 6
Page
Cleaning the Ice Maker System....... 7
Cleaning the Interior Components.. 8
Filtering and Treating Water ........ 9
VACATION AND MOVING CARE ........... 9
IF YOU NEED SERVICE OR ASSISTANCE 10
1. Before Calling for Assistance...... 10
2. If You Need Assistance............. 11
3. If You Need Service................. 11
4. If You Have a Problem.............. 11
©1985 Whirlpool Corporation
Before you plug it in
IMPORTANT
Before using your ice maker, you are
personally responsible for making sure that it...
• has been installed where it is protected from
the elements.
• is located so that the front is not blocked to
restrict incoming or discharge air flow.
• is properly leveled.
• is located in a well ventilated area with
temperatures above 55°F (13°C) and below
110°F (43°C). Best results are obtained
at temperatures between 70°F (21°C)
and 90°F (32°C).
• is properly connected to a water supply and
drain.
• is properly connected to electricity. A115
Volt, 60 Hz., 15 amp fused electrical supply is
required. NOTE: Time delay fuse or circuit
breaker is recommended.
• is properly electrically grounded.
• is not operated by anyone unable to use
if properly.
• is used only for the job it was designed to
perform.
• is properly maintained.