Other operating instructions, For a rinse and spin, For a soak – Whirlpool LA558oXP User Manual
Page 10: Cleaning the lint filter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de
tergent can require an extra rinse.)
• Push Control Knob In.
• Turn clockwise to any *on the dial.
See above drawing.
• Pull Control Knob out.
• The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For agitation and spin speeds in
For a soak
For best results, use
warm
water for
soaking stained laundry.
Hot water
can set stains.
*To start soak with agitation,
must point to a number
Cleaning the lint filter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it’s clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc
tions for cleaning are printed on the
bottom of the tilter.
10
Your washer can be set to drain
and spin out water.
• Push Control Knob in.
• Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
• Pull Control Knob out.
• The washer will drain and spin.
each cycle,see pages 6-9.
• Use recommended amount of
detergent or pre-soak product.
• Push Control Knob in.
• Turn clockwise to point at a
number
in the SOAK Cycle.*
• Pull Control Knob out to start washer.
• When the cycle is over, add de
tergent for the next selected wash
cycle.
The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
Information on page 7 of your
“Laundry Guide.”
the Cycle Control Knob
in the SOAK Cycle.