Whirlpool FGS385Y - Manual (Page 24)

C A R I N G F O R Y O U R R A N G E
5. Before putting the burners back, dry them
thoroughly by setting them in a warm oven for
30 minutes.
6. Replace burners, making sure they are
properly seated and level. Replace screws.
7. Occasionally check the burner flames for
proper size and shape as shown. A good
flame is blue in
color. If
flames lift off ports, are
yellow, or are noisy when turned off, you may
need to clean the burners (see page 23), or
call a qualified technician for adjustment.
Typical surface burner flame
at highest setting
Cleaning chart
Use the following table to help you clean your range.
PART WHAT TO USE HOW TO CLEAN
Control knobs Sponge and warm,
soapy water • Turn knobs to OFF and pull straight away
from control panel.
• Wash, rinse and dry thoroughly. Do not soak.
• Replace knobs. Make sure all knobs point to
OFF.
DO NOT USE steel wool or abrasive cleaners.
They may damage the finish of the knobs.
Control panels Sponge and warm,
soapy water
OR
Paper towel and spray
glass cleaner • Wash, rinse and dry thoroughly.
DO NOT USE steel wool or abrasive cleaners.
They may damage the finish.
DO NOT SPRAY cleaner directly on panel.
Apply cleaner to paper towel.
Exterior surfaces
(other than control
panels)
Sponge and warm,
soapy water
• Wash, rinse and dry thoroughly.
USE nonabrasive, plastic scrubbing pad on
heavily soiled areas.
• Do not use abrasive or harsh cleansers.
They may damage the finish.
NOTE: Do not allow foods containing acids
(such as vinegar, tomato or lemon juice) to
remain on surface. Acids may remove the
glossy finish. Also wipe up milk or egg spills
when cooktop is cool.
Surface burner
grates and
reflector pans Warm, soapy water and
a nonabrasive, plastic
scrubbing pad
OR
Dishwasher • In dishwasher, wash with other cooking
utensils.
• Dry completely.
• Do not use abrasive or harsh cleansers.
2 4