Whirlpool RB16OPXL - Manual (Page 4)

Using Y^ur oven
Automatic MEALTIMER* Clock Manual Oven Light Switch Adjustable Oven Temperature Control
\
Minute Timer Start Time Knob Stop Time Knob Clean Light Lock Light
\
Oven Selector
SETHNC THE CONTROLS
BAKING
1. Put oven racks where you want them.
(See page 5 for suggestions.)
2. Set Oven Selector to BAKE.
3. Set Oven Temperature Control to the bak­
ing temperature you want.
4. Let the oven preheat until the Signal Light
goes off.
5. Put food in the oven.
6
.
When done baking, turn both knobs to
OFF.
During baking, the elements will him on
and off to help hold the oven temperature at
the setting. (The top element wHI never turn
red, but will be hot.) The Signal Light wMI turn
on and off with the elements.
RESETTING THE OVEN TEMPERATURE CONTROL
Does your new oven seem to be hotter or colder than your old oven at the
same settings? The temperature setting In your old oven may have changed
gradually over the years. The accurate setting of your new oven can seem differ­
ent. If you think the oven temperature needs adjusting, follow these steps:
Locking Screw
Notches Tooth
1. Pull the Oven Tem­
perature Control
straight off.
2. Loosen the lock­
ing screw;
NOTICE position
of notches.
3. To lower the
tempeiatuie, move
a notch closer to LO.
Each notch equals
about 10*F (5"C).
4. To raise the
temperature, move
a notch closer to HI.
Each notch equals
aboutlO'F (S-C).
Tighten the locking screw. Replace the kncb.