Other operating instructions, Rinse and spin, Drain and spin – Whirlpool LT7004XV User Manual
Page 11: Soak cycle, Pre-wash cycle
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
other Operating Instructions
Rinse and spin
When using extra detergent for heavily
soiled clothes, or washing special-care
items, you may want an extra rinse
and spin.
1. Push Cycle Control Knob in.
2. Turn clockwise to one of the dots on
the dial, as illustrated.
3. Pull Cycle Control Knob out. The
washer will fill to selected level,
agitate 2-4 minutes depending on
the cycle selected, drain and spin.
Drain and spin
A drain and spin may help shorten
drying times for some heavy fabrics or
special-care items by removing excess
water.
1. Push Cycle Control Knob in.
2. Turn clockwise to any bar just
before an OFF area on the dial,
as illustrated.
3. Pull Cycle Control Knob out. The
washer will drain and spin.
Soak Cycle
For best results, use warm water for
soaking stained laundry. Hot water can
set stains.
1. Use recommended amount of
pre-soak product or detergent.
2. Push Cycle Control Knob in.
3. Turn clockwise to point to the
number next to SOAK.
4. Pull the Cycle Control Knob out.
The washer will start.
5. When the cycle is over, add
detergent for the next selected wash
cycle. The SOAK Cycle should al
ways be followed by a wash cycle.
NOTE: See the Laundry Guide for
additional soaking information.
Pre-wash Cycle
For best results, use warm water for
pre-washing stained laundry. Hot water
can set stains.
11