Whirlpool EVISHKXK - Manual (Page 3)

Using your freezer
Setting the Cold Control...
To start, turn control to the middle of the dial.
This setting will maintain zero zone temperatures
under normal operating conditions.
Adjusting Cold Control...
• Turn control to higher number for colder
temperatures.
• Turn to lower number for less cold temperatures.
Cooling Freezer First...
• Allow freezer to cool 6 to 8 hours before filling
with frozen food.
• Let it cool overnight before adding large
amount of unfrozen food.
Note: When freezer is first started the compressor
will run constantly until the cabinet is
cooled. It
may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times
the treezer door is opened.
Atterthe cabinet is cooled the compressor will
turn on and off as needed to keep freezer at
proper temperature.
Freezer Shelves...
To remo'-e:
Lift front slightly, then lift shelf from back supports.
To repla :;e:
Set bock of shelf on rear supports then lower
the front on to front mounts.
Bottom Trivet...
To remove:
• Lift up, then pull out.
To replace:
• Set in bottom of freezer.
• Push into place.
Exterior Signal Light...
automatically warns of any unexpected power
failure.
Signal light
If the signal light is not glowing, immediately
check:
• tor power interruption,
• the power cord; it may be disconnected from
the outlet,
• the signal light; it may be burned out.
To replace burned out signal light:
1. Unpiiig power cord from outlet.
2. Remove base grille. See page 4.
3. Unplug burned out light and replace with one
of same wattage and size. Signal light can be
ordered from your WHIRLPOOL dealer. Part No.
530584.
4. Repicice base grille. See page 4.
5. Plug p ower cord into outlet.