Install properly, Level freezer, Remove sales labels – Whirlpool EVISHKXK User Manual
Page 2: Clean it, Plug it in, Before you plug it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before you plug it in
Before using your freezer, you ore personally
responsible for making sure that it...
• is installed and leveled on a floor that will
hold the weight, and in an area suitable for
its size and use.
• is oonnected only to the right kind of outlet,
with
the
right
electrioal
supply
and
grounding.
• is used only for jobs expected of home
freezers.
• is not near an oven, radiator or other heat
source.
• is properly maintained.
• is in Cl dry sheltered place.
• is used in an area where the room tempera
ture V ill not exceed IIO^F (43.3°C).
• is not run where there are explosive fumes.
• is not used by children or others who may not
understand how it should be used.
• is not loaded with food before it has time to
get properly cold.
Install Properly...
1. Check the strength of the floor. It should hold
the weight of fully loaded freezer.
2 Pick a safe place, indoors, away from in
flammables such as gasoline.
3. Allow at least 3 inches (7.5 cm) air space on
top of freezer and 1 inch (2.5 cm) at back be
tween condenser and wall.
Level Freezer...
so that door will stay open at any position.
Remove base grille (see page 4).
|
Starting with door hinge side,
turn left to raise corner.
Turn right to lower corner
Check with level.
After freezer is loaded with
food, recheck with level.
Raise
Lower
Remove Sales Labels...
Rem )ve the Consumer Buy Guide label and
any in .ide labels before using the freezer. Re
move (uny left over glue with rubbing alcohol.
Note: DO NOT REMOVE the Tech Sheet fas
tened behind the base grille.
Clean It...
Clean your freezer before using if. See clean
ing inst'uctions on page 5.
Plug
it
in...
Recommended Grounding Method
A 12( Volt, 60 Hz„ AC only, 15 ampere fused
electric al supply is required. It is recommended
that a separate circuit serving only this appli
ance t e provided. The receptacle should not
be controlled by a wall switch or pull chain.
Do not use an extension cord.
See
ndividual
electrical
requirements
and
grounding instruction sheet in your literature
packaqe.