Other operating instructions, For a soak, Cleaning the lint filter – Whirlpool LA53OOXP User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Other operating instructions
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de
tergent can require an extra rinse.)
• Push Control Knob In
• Turn clockwise to any*on the dial.
See above drawing.
• Pull Control Knob out
• The washer will fill to selected level;
agitate 2 minutes; drain and spin.
For a soak
For best results, use
warm
water
for soaking stained laundry.
Hot
water can set stains.
• Use recommended amount of
detergent or pre-soak product.
Your washer can be set to drain
and spin out water.
• Push Control Knob In.
• Turn clockwise to the barjust before
OFF in any cycle. See above
drawing.
• Pull Control Knob out.
• The washer will drain and spin.
• Push Control Knob In.
• Turn clockwise to point at a
number
in the SOAK Cycle...use the 6-minutes
mark for o pre-wash.*
' Pull Control Knob out to start washer.
' When the cycle is over, add de
tergent for the next selected wash
cycle
The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“Laundry Guide.”
Set the washer and start the next
selected wash cycle.
*To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint filter
Clean filter after every load for best
filtering results.
Note: The load type
will vary the amount of lint build-up.
To clean:
• Lift off the agitator barrel.
• Wash or wipe the filter clean in the
bottom of the agitator barrel.
The
filter is not removable.
• Replace the agitator barrel and
snap into place.