beautypg.com

Step 2 - make hole for filtered water faucet, Step 3 - install faucet – Whirlpool WHED10 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Step 2 - Make Hole For Filtered Water Faucet

IMPORTANT: To avoid damaging the sink, consult a qualified plumber or installer for drilling

procedures in porcelain or stainless steel. Special drill bits are made for this.

Select one of the following places to install the faucet. Be sure there’s room underneath so you can

make the needed connections.

In an existing sink spray attachment hole

Drill a hole in the sink top.

Drill a hole in the countertop next to the sink.

1. If drilling is needed make a 1-3/8” dia. (minimum) hole for the faucet.

Step 3 - Install Faucet

1. Slide the toggle bolts through the mounting hole. Tighten the screws to secure the base flat on the

mounting surface.

2. Feed a length of 3/8” tubing through the hole and connect to the quick connect fitting on the bottom

of the faucet.

3. Move the faucet down onto the base. Turn 1/4 clockwise to attach the faucet to the base.

screw

toggle bolt

TUBING FROM DRINKING

WATER SYSTEM

faucet base

rubber washer

hole In sink or

countertop

Figure 3