Whirlpool WHED10 - Manual (Page 2)

Table of Contents
Parts of the System / Typical Installation Drawing / Tools and Materials Needed............................................................ 4
Drinking Water Filter System Installation.......................................................................................................................... 5
Installing Supply Fitting..................................................................................................................................................... 5
Installing Faucet.................................................................................................................................................................. 5
Installing Filter Cartridge.................................................................................................................................................... 7
Filter Cartridge Life / Replacement.................................................................................................................................... 7
Repair Parts ........................................................................................................................................................................ 10
Before You Start
C Read all steps and guides carefully before installing and using your undersink drinking water filter
system. Follow all steps exactly to correctly install. Reading this manual will also help you to get all
the benefits from the undersink drinking water filter system.
C Do not use with water that is microbiologically unsafe or of unknown quality without ade­
quate disinfection before or after the system. This system is certified for cyst reduction and may
be used on disinfected waters that may contain filterable cysts.
C All plumbing should be done in accordance with local codes and requirements. In Massachu­
setts, plumbing code 248 CMR 3.00 and 10.00 shall be adhered to. Consult with your licensed
plumber.
C The undersink drinking water filter system works on water pressures of 30 psi (minimum) to 125
psi (maximum). If your house water pressure is over the maximum, install a pressure reducing valve
in the water supply pipe to the filter system.
C Do not install the undersink drinking water filter system outside, or in extreme hot or cold tempera­
tures. Temperature of the water supply to the undersink drinking water filter system must be between
40°F and 100°F. Do not install on hot water.
Min. - Max. Supply Water Pressure
Min. - Max. Supply Water Temperature
Inlet - Outlet
30- 125 psi (207 - 862 kPa)
40 - 100 °F (4 - 38 °C)
3/8” quick connect fittings and tubing included