Parts of the system, Materials and tools needed, Typical undersink installation – Whirlpool WHED10 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Parts of the System
filter system assembly including mounting bracket and screws
water supply fitting
filtered water faucet for sink or countertop mounting
3/8” tube benders
3/8” tubing to make all needed connections
Materials and Tools Needed
NOTE:
Gather the requiredtools before starting installation. Read andfollow the instructions
provided with any tools listed here.
IMPORTANT: To avoid damaging the sink, consult a qualified plumber or installer for drilling
procedures in porcelain or stainless steel.
•
slotted and Phillips screwdrivers
•
pliers and adjustable jaw wrench
•
tubing cutter
•
electric drill and 1-3/8” drill bit if mounting hole is needed for the faucet
Typical Undersink Installation
Locate the water filter housing on the cold water supply pipe, under the kitchen and/or bathroom sink,
to filter the cold drinking water. Refer to the following drawing.
benders to prevent kinking.
Figure 1
NOTE: Aiiow a minimum space of 1-1/2” under the system for
removing the housings (to change the cartridges).