Other operating instructions, For a rinse and spin, For a drain and spin – Whirlpool LT4900XM User Manual
Page 10: For a soak or pre-wash, Lint filter
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Other operating instructions
For a rinse and spin
• Push Control Knob in.
• Turn olockwise to any
dot
on the
dial. See above drawing.
• Pull Control Knob out.
• The washer will fill with
rinse water,
agitate 2 minutes, drain and spin.
For a drain and spin
• Push Control Knob in.
• Turn clockwise to the
bar
just
before OFF in any cycle. See
above drawing.
• Pull Control Knob out.
• The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 8 and 9.
For a soak or pre-wash
• Use enough detergent or pre-soak
product for a single load
• Push Cycle Control Knob in.
• Turn clockwise to point at a num
ber in the SOAK Cycle.
• Pull Control Knob out.
• When the cycle is over, add de
tergent for the next seleoted wash
cycle
(IMPORTANT: See page 7 in
“Laundry Guide.”)
• Set the washer and start the next
selected wash cycle
To start the soak or pre-wash with agitation, the Cycle Control
Knob must point to a number in the SOAK Cycle.
Lint filter
Cleanthe
lintfilteraftereach
load.
Press the release and pull it straight
out.
Instructions
for
cleaning
are
printed on the bottom.