Installing it properly, Leveling it – Whirlpool 3VED29DQ User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE USING YOUR REFRIGERATOR
Installing it properly
1. Allow 1.25 cm
(V2
inch) space on each
side and at the top of the refrigerator for
ease of installation.
2. If the refrigerator is to be against a wall,
you might want to leave extra space on
the hinge side closest to the wall so the
door can be opened wider.
For 3VED29DQ only: A minimum of
2.9 cm (1'/8 inch) between the refrigerator
door and wall is required, or a minimum
of 3.8 cm (V
/2
inch) between the freezer
door and wall is required.
3. The refrigerator can be flush against the
wall.
4. Make sure ice maker water supply has
been connected. Refer to Installation
Instructions.
Leveling it
Your refrigerator has 2 front leveling
screws-one on the right and one on the left.
To adjust one or both of these, follow the
directions below.
1. Remove base grille. (See page 16.)
2. To raise front, turn screw clockwise.
3. To lower front, turn screw counterclock
wise.
4. Check with level.
5. Replace base grille. (See page 16.)
Right to raise;