beautypg.com

Other operating instructions, Cleaning the lint filter, For a soak or pre-wash – Whirlpool LASOOXP User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Other operating instructions

You may need an extra rinse and

spin for heavily soiled loads which

need more detergent.(Extra de­

tergent can require an extra rinse.)
• Push Control Knob in.
• Turn clockwise to any*onthedial.

See above drawing.

• Pull Control Knob out.
• The washer will fill to selected level

with

cold

water, agitate

2

minutes,

drain and spin.

For a soak or pre-wash

For best results, use warm water

tor soaking or pre-washing stained
laundry.

Your washer can be set to drain

and spin out water.
• Push Control Knob in.
• Turn clockwise to the bar just before

OFF in any cycle. See above

drawing.

• Pull Control Knob out.
• The washer will drain and spin.

For agitation and spin speeds in each
cycle, see pages 6 and 7.

• Use enough detergent or pre-soak

product for a single load.

• Push Control Knob in.

• Turn clockwise to point at a

number

in the SOAK Cycle,

• Pull Control Knob out.
• When the cycle is over, add de­

tergent for the next selected wash

cycle. Important: See additional
care information on page 7 of your

"Laundry Guide.’’

• Set the washer and startthe next

selected wash cycle.

To start the soak or pre-wash with agitation, the Cycle Control

Knob must point to a number in the SOAK Cycle.

Cleaning the lint filter

Clean filter after every load for best

filtering results.

Note: The load type

will vary the amount of lint build-up.

• Lift offthe agitator barrel.
• Rinse or wipe the filter clean in the

bottom of the agitator barrel.

The

filter is not removable.

• Replace the agitator barrel and

snap into place.

8