I sing the dry ing rack, Changing the drum light, End-of-cycle signal – Whirlpool LE9800XM User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

I sing the dry ing rack
The drying rack lets you dry items
that you may not want to tumble; for
example, sneakers, stuffed toys
knitted wool, etc
The rack does not move, but the
drum turns Make sure nothing hangs
over the edges of the rack.
1.
Fit rear legs
2.
of the rack
into indents
in back
wall of
dryer.
Lower the
front so legs
rest on dryer
opening
PUSH IN
FRONT LEGS
3.
Put wet Items on fop of the rack.
Leave space between them
so air can reach all surfaces
4.
Close the door; touch a TIMED
DRY Control selection.
Drying time will depend on how
much moisture the items hold. The
following chart suggests tempera
ture settings for different kinds of
items that might best be rack dried.
To rack dry... Use FABRIC-TEMP
selection...
Wool sweaters
(Block to shape;
lay flat on rack).
KNITS
GENTLE LOW
Stuffed toys or pillows
(Cotton or polyester
fiber filled.)
PERM'T
PRESS/MED
Stuffed toys or pillows
(Foam rubber filled.)
FLUFF AIR
Sneakers or
canvas shoes
FLUFF AIR
WARNING: Drying plastic or rubber
items with heat may damage
the items or be a FIRE HAZARD.
Be sure to take the rack out for
normal tumble drying.
8
Changing the drum light
1.
Unplug the dryer to avoid
possible electrical shock.
2.
Open the
dn.'er aoor
a n d remove
light bulb
cover by
turning if
clockwise,
3.
Remove the
light bulb by
turning it
counter
clockwise.
4.
Replace the bulb only with a 40
watt appliance bulb from most
hardware, grocery or variety
stores,
5.
Replace the light bulb cover
and lock it in place by turning
counterclockwise.
CAUTION: The bulb cover
must be securely in place
during dryer operation
to prevent overheating
and possibie damage to
fabrics. Operating the
dryer with the buib cover
removed can cause the
dryer to faii or create
a FIRE HAZARD.
End-of-cycle signal
The dryer will beep 5 times to let
you know when the cycle is finished.
It will also beep after each FINISH
GUARD tumbling.
The signal is helpful when you are
drying permanent press, synthetics
and other items that should be taken
out as soon as the dryer stops.
The signal can’t be turned off and
it is not adjustable.