Starting your dryer and selecting a cycle, Turn power on, Touch fabric-temp 2. selector – Whirlpool LE9800XM User Manual
Page 4: Touch a custom dry 3. or timed drv control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Starting your
dryer and
selecting a cycle
Before starting your dryer, be
sure laundry is sorted and loaded
properly (see your'’DryerGuide")
Be sure the door is tightly closed.
Imrf cmpmcity
Dry-Miur Control
Cfwoy Eriicwnt Syalwn
/
1.
Turn
power on
i :
Touch FABRIC-TEMP
2. Selector
fabric-temp selector
Move the POWER SWITCH up.
You will have 8 seconds to touch
a FABRIC-TEMP Selector.
Within 8 seconds, touch the lower
part of a FABRIC-TEMP Selector. The
dryer will not operate if you touch the
upper half of the selector.
You may change the dryer setting
at any time during any cycle by
touching the desired selector or
selectors.
Touch a CUSTOM DRY
3. or TIMED DRV Control
IMPORTANT: If you do not touch a
CUSTCM DRY or TIMED DRY Control,
the dryer will automatically select
NORMAL DRY.
If this is not the dryness you like,
you must touch one of the other
dryness Controls. See page 6 of this
book for more details.
4
• To stop the dryer
1. Cpenthedoor,or...
2. Move PCWER SWITCH to CFF.
• To check the load
1. Cpen door.
2. The dryer will remember where it
was in the cycle if you restart the
dryer within 2 minutes. Touch
selector with the blinking lightto
restart.