Removing the freezer shelves, Removing freezer bin, Changing the light bulbs – Whirlpool ED19HK User Manual
Page 7: Removing the base grille, Ice cube trays, W •* fr
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing the freezer shelves.
Lift the Front
Then the Back
Removing freezer bin...
For proper air movement, keep the freezer bin in
place when the refrigerator is operating.
To remove the bln:
• Slide out to the stop.
• Lift the front to clear the stop.
• Slide out the rest of the way.
To replace the bln:
• Place bln on the slides.
• Make sure the stops clear
the front of the slides.
• Slide bin in.
1. Lift front slightly.
2. Lift back off supports.
3. Replace in reverse order
''W •* fr
Ice cube trays...
To remove ice:
1. Hold tray at both ends.
2. Slightly twist.
If cubes ore not used, they may shrink. The moving
cold air starts a slow evaporation. The longer cubes
are stored, the smaller they get.
Changing the light bulbs...
WARNING: Before removing the light bulb, either
unplug the refrigerator or disconnect
the electricity leading to the re
frigerator at the main power supply.
Shock and injury can occur if elec
tricity remains connected.
Light blubs behind refrigerator and freezer
control consoles:
1, Pull control knob straight off
2, Pull bottom of control panel straight out.
3, Lift top of panel off supports.
4, Replace with a 40-watt appliance bulb,
5, Replace panel in reverse order.
Pull Off the Dial;
Pull Out at the Bottom
Removing the base grille..
1. open the doors.
2, Pull grille outwards as shown
3,
Do not remove Tech sheet
fastened behind grille
Support Tabs
To replace:
1, Line up grille support tabs with metal clips
2, Push firmly to snap into place,
3, Close the doors