beautypg.com

Install properly, Level refrigerator-freezer, Remove sales labels – Whirlpool ED19HK User Manual

Page 4: Plug it in, Clean it

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Install properly...

1. Allow

'/2

inch (1.25 cm] space on each side and at

the top of the refrigerator for ease of installation,

2. If the refrigerator is to be against a wall, you might

want to leave extra space so the door can be
opened wider.

3. The refrigerator back can be flush against the wall.

Level refrigerator-freezer.

1

. Remove base grille (see page 7).

2. To raise front, turn each screw to the right.
3. To lower front, turn each screw to the left.

4. Check with level.

Remove sales labels...

Remove the Consumer Buy Guide label, tape and

any inside labels before using the refrigerator
To remove any remaining glue:

1. Rub briskly with thumb to make a ball then remove.

OR
2. Soak area with dishwashing detergent solution (1

teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or

toxic solvents, such as acetone, gasoline, car­

bon tetrachloride, etc. These can damage the
material.

NOTE: DO NOT REMOVE ANY PERMANENT IN­

STRUCTION LABELS INSIDE YOUR REFRIGERATOR.

Do not remove the Tech Sheet fastened under

the refrigerator at the front.

Clean it...

Clean your refrigerator

before using it.
See cleaning instructions
on page 9.

Plug it in...

3-prong grounding
type wall receptacle

3-prong
grounding plug

Refrigerator

Power Cord

RECOMMENDED GROUNDING METHOD

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is re­
quired. It is recommended that a separate circuit
serving only this appliance be provided.

Do not use an extension cord. Use a recep­

tacle which cannot be turned off with a switch
or pull ohain. See individual electrical require­

ments and grounding instruotion sheet in your liter­
ature package.