Whirlpool 340 1094 - Manual (Page 21)

C A R I N G F O R Y O U R D R Y E R
Changing the drum light
(on some models)
The dryer light automatically turns on inside
the dryer drum when you open the door.
AWARNING
2. Open the dryer door. Remove the light
bulb cover from the back
wall of the dryer by turning
the cover clockwise.
M
Fire Hazard
Unplug dryer before changing
light bulb.
Replace light bulb cover before
operating dryer.
Failure to do so can result in death,
fire, or electrical shock.
3. Remove the light bulb by turning it
counterclockwise.
4. Replace the bulb with a 40-watt appliance
bulb only.
5. Replace the light bulb cover and lock
in place by turning counter­
clockwise.
6. Reconnect power supply.
To change drum light:
1. Unplug the dryer or disconnect the elec­
tricity leading to the dryer at the main
power supply.
Vacation care
1. Unplug power supply cord or turn off
electrical power supply.
2. Clean lint screen.
Saving energy
• Use an Automatic cycle to dry most loads.
• Dry only full loads without overdrying.
• Avoid overloading dryer, adding wet items
to a partly dried load, or opening the door
unnecessarily.
• Plan your laundry to dry one load after
another. A warm dryer shortens
drying time.
’ Shorten drying times by exhausting dryer
properly and cleaning exhaust duct and
outside exhaust hood as needed.
- Keep the lint screen clean.
- Use your dryer in a room where room air
temperature is above 45°F (7°C).
- Sort loads by fabric weight and type.
21