Other operating instructions, For a rinse and spin, For a drain and spin – Whirlpool LA5380XM User Manual

Page 8: For a soak or pre-wash, Cleaning the lint hlter

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Other operating instructions

For a rinse and spin

You may need an extra rinse and

spin for heavily soiled loads which
need more detergent. (Extra de

tergent can require an extra rinse.)

• Push Control Knob in.
• Turn clockwise to any * on the dial.

See above drawing.

• Pull Control Knob out.
• The washer will fill to selected level

with cold water, agitate 2 minutes,
drain and spin.

For a drain and spin

Your washer can be setto drain

and spin out water.
• Push Control Knob in.

• Turn clockwise to the bar just before

OFF in any cycle. See above
drawing.

• Pull Control Knob out.
• The washer will drain and spin.

For a soak or pre-wash

For best results, use warm water

for soaking or pre-washing stained
laundry.

' Use enough detergent or pre-soak

product for a single load.

' Push Control Knob in.
' Turn clockwise to point at a number

in the SOAK Cycle.

' Pull Control Knob out.
' When the cycle is over.add de

tergent for the next selected wash

cycle. Important: See additional
care intormation on page 7 ot your
“Laundry Guide.”
Setthe washer and start the next
selected wash cycle.

To start the soak or pre-wash with agitation, the Cycle Control

Knob must point to a number in the SOAK Cycle.

Cleaning the lint Hlter

Water runs through the lint filter

whenever the washer agitates.
Check it often to make sure it’s clean
and is filtering at its best.

To remove it for cleaning, press the

release and pull straight out. Instruc
tions for cleaning are printed on the

bottom of the filter.