Before using your refrigerator, Cleaning your refrigerator, Removing packaging materials – Whirlpool 3VED23DQDW00 User Manual

Page 7: Cleaning it before use, Plugging it in

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Before Using Your

Refrigerator

It is important to prepare your refrigerator for use. This section tells you how to clean
it, connect it to a power source, install it, and level it.

Cleaning your refrigerator

Removing packaging materials

Remove tape and any inside labels
(except the model and serial number
label) before using the refrigerator.

To remove any remaining giue:

• Rub briskly with thumb to make a ball,

then remove.

• Soak area with liquid hand dish

washing detergent before removing
glue as described above. Do not use
sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners.
These can damage the material.

See “Important Safety Instructions" on
page 3.

NOTE:

Do not remove any permanent

instruction labels inside your refrigera
tor. Do not remove the Tech Sheet
fastened under the refrigerator at the
front.

Cleaning it before use

After removing all packaging materials,

clean your refrigerator be
fore using it, if necessary.

See cleaning instructions
on pages 22-23.

Plugging it in

Recommended Grounding Method

A 115 Volt/60 Hz (Plug 1), 220/240 Volt/

50 Hz (Plug 2 or 3) or 220 Volt/60 Hz
(Plug 3) AC only 15 or 20 ampere fused
and properly grounded electrical supply
is required. It is recommended that a
separate circuit serving only this appli
ance be provided. Use a receptacle
which cannot be turned off with a switch
or pull chain. Do not use an extension
cord.

Plug 1

Plug 2