Whirlpool EV15HK - Manual (Page 4)

Install properly...
' Check the strength of the floor It should hold the
weight of a fully loaded freezer.
2 Pick a safe place, indoors, away from in­
flammables such as gasoline.
3, Allow 3 inchet (7 5 cml airspace on top of freezer
for proper ventiiahon
4 Allow' of lecrt an 'Och [2 5 cm] oefw-een the
freezer cond'-nser, on the back of the unit, and
the wal
b Allowt, inch 2 25 cm] on each side ct the freezer
for ease of in'.’allation
6. If the freezer i; "o be in a corner, you might want to
leave extra syoce on the hinge side so the door
can be opened wider.
’ The four Dolts mat held your freezer in the shipping
crate ore designed to be the levelling legs. Screw
the legs far erough into the bolt holes, in each of
the four bottr.mn corners, so the freezer stands
about ■ mch , . ' 5 cm] off the floor
Level freezer...
so the door will stay open at any position
This freeze: has 2 threaded leveling legs that are
shipped in a separate package.
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer.
To remove any remaining glue:
1, Rub briskly with thumb to make a ball, then
remove
OR
2, Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be­
fore removing glue as described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the
surface finish.
NOTE: DO NOT REMOVE the Tech Sheet fas­
tened under the freezer at the front.
Plug it in...
Screw these legs all the way into bolt holes in the
bottom front corners of the freezer.
Slide the freezer into place.
Adjust fropr legs to level the freezer
- To raise front, turn legs clockwise
- To lower front, turn legs counterclockwise.
Check with level
After freezer is fully loaded, recheck with level
Recommended Grounding Method
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded eleotrioal supply Is re­
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned otf with a
switch or pull chain. Do not use an extension
cord.
Attach retaining clip over power cord plug
from literature package inside the freezer.