Whirlpool EV190N - Manual (Page 6)

Changing the light bulb...
Light Shield,
^WARNING
Electrical Shock Hazard
Before removing a light bulb, either unplug
the freezer or disconnect the electricity
leading to the freezer at the main power sup­
ply. Shock and injury can occur if electricity
remains connected.
1. Disconnect freezer from power supply.
2. Remove the light shield from fhe side of fhe con­
trol panel. Depress the back of fhe shield fo re­
lease the tabs, then pull away.
3. Replace the bulb with a 40-watt appliance
bulb.
4. Replace the light shield. Insert the shield tabs in
the slots, then press the shield to snap into place.
5. Reconnect power supply.
Removing the freezer basket...
For proper air movement, keep the freezer basket
in place when the freezer is operating.
To remove the basket:
• Slide out to the stop.
• Lift the front to clear the stop.
• Slide out the rest of the way.
To replace the basket:
• Place basket on the slides.
• Make sure the wire stops
clear the front of the slides.
• Slide basket in.
The key eject lock...
can help reduce the hazard of child
entrapment.
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
If the key Is lost, contact your WHIRLPOOL
dealer for a replacement. Always give the com­
plete model and serial number of your freezer
when requesting a replacement key.
The signal light...
automatically warns of any unexpected
power failure.
Signal Light
If the signal light is not glowing, immediately check:
• for power interruption,
• for an unplugged power cord,
• for a burned out signal light.
To replace burned out signal light:
1. Unplug power cord from outlet.
2. Open the freezer door.
3. Unplug burned out light and replace with one of
same wattage and size. Signal light can be or­
dered from your WHIRLPOOL dealer. Part No.
1103639.
4. Close freezer door and plug power cord into outlet.