Clean it, Remove sales labels, Plug it in – Whirlpool EV190N User Manual

Page 4: Install properly, Level freezer, Before using your freezer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Before using your freezer

1. Clean it...

Clean your freezer before using it. See cieoning

instructions on page 7.

2. Remove sales labels...

Remove the Consumer Buy Guide iobel and any

inside

iobeis before using the freezer.

To remove any remaining giue:

1. Rub briskly with thumb to moke o boii, then

remove.

2. Soak area with dishwashing detergent solution

(1 teaspoon detergent in 1 quart warm water) be
fore removing giue as described in step 1.

DO NOT USE rubbing aicohoi or fiammabie or

toxic soivents, such as acetone, gasoiine, car

bon tetrachioride, etc. These can damage the

surtace tinish.

NOTE: DO NOT REMOVE the Tech Sheet fas

tened under the freezer at the front.

3. Plug it in...

3-prong grounding

type wall receptacle

Retaining Clip

Freezer

Power Plug

3-prong

grounding plug

Recommended Grounding Method

A115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply is re
quired. It is recommended that a separate circuit
serving only this appliance be provided.

Use a

receptacle which cannot be turned off with a
switch or pull chain. Do not use an extension
cord.

Attach retaining clip over power cord plug from

literature package inside the freezer.

4. Install properly...

1. Check the strength of the floor. It should hold the

weight of a fully loaded freezer.

2. Allow 3 inches (7.5 cm) air space on fop of

freezer for proper ventilation.

3. Allow at least an inch (2.5 cm) between the

freezer condenser, on the back of the unit, and
the wall.

4. Allowy

inch (1.25 cm) on each side of the freezer

for ease of installation.

5. If the freezer is to be in a corner, you might want

to leave extra space on the hinge side so the
door can be opened wider.

5. Level freezer...

so the door will stay open at any position.

This freezer has 2 threaded leveling legs that are

shipped in a separate package.

1. Screw these legs all the way into bolt holes in the

bottom front corners of the freezer.

2. Slide the freezer info place.
3. Adjust front legs to level the freezer.

- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.

4. Check with level.
5. After freezer is fully loaded, recheck with level.