The water dispenser, Using the automatic ice maker – Whirlpool 4VED29DQ User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING YOUR REFRIGERATOR
The water dispenser
Chilled water comes from a tank behind the
meat drawer. It holds approximately 1.5 L
(V
/2
quarts).
When you hook up the refrigerator for the
first time, press the water dispenser bar with a
glass or jar until you draw and discard 1.9 to
2.8 L (2 to 3 quarts). The water you draw and
discard rinses the tank and pipes. Allow
several hours to chill a new tankful.
NOTE: The small tray beneath the dispenser
evaporates
small
spills. There is no drain in
this tray.
Do not
pour water into it.
To dispense water:
1
. Press a
sturdy
glass against the water
dispenser bar.
2. Remove the glass to stop dispensing.
NOTE: Dispense enough water every week to
maintain a fresh supply.
The dispenser light
To turn on night light,
slide dispenser LIGHT
switch to the left. See page 16 for directions
for changing the dispenser light bulb.
WATER LIGHT
a
D □
Using the automatic ice maker
Here are a few things you will want to know
about your automatic ice maker:
• The ON/OFF lever is a wire signal arm.
Down ... to make ice automatically.
Up ... to shut off the ice maker.
NOTE: Do not turn ice maker on until it is
connected to the water supply.
Instruc
tions for Ice maker water supply hook
UP
are attached to the back of the
refrigerator cabinet.
• It is normal for ice crescents to be attached
by a corner. They break apart easily.
• The ice maker will not operate until the
freezer is cold enough to make ice. This
can take overnight.
• If ice is not being made fast enough and
more ice is needed, turn the Refrigerator
Control toward a higher number. Wait a
day and, if necessary, turn the Freezer
Control toward C.
Raise signal
arm to stop
ice maker.
Lower signal
arm to start
ice maker.
13