Other operating instructions, For a rinse and spin, For a soak – Whirlpool LA5311XP User Manual

Page 10: For a drain and spin, Cleaning the lint filter

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Other operating instructions

For a rinse and spin

You may need an extra rinse and

spin for heavily soiled loads which

need more detergent. (Extra de

tergent can require an extra rinse.)
• Push Control Knob in.
• Turn clockwise to any • on the dial.

See above drawing.

• Pull Conrrol Knob out,
• The washer will fill to selected

level; agitate 2 minutes; drain
and spin.

For a soak

For best results, use warm water

for soaking stained laundry. Hot
water can set stains.

• Use recommended amount of

detergent or pre-soak product.

• Push Control Knob in.

For a drain and spin

Your washercan be seftodrain

and spin out water.
• Push Control Knob in.
• Turn clockwise to the bar just before

OFF in any cycle. See above
drawing.

• Pull Control Knob out.
• The washerwill drain and spin.

Turn clockwise to point at a number

in the SOAK Cycle...use the 6-minute
mark for a pre-wash.*

Pull Control Knob out to start washer.
When the cycle is over, add de
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash

Cycle.
Important: See additional care
information on page 7 of your
“Laundry Guide.”

> Set the washer and start the next

selected wash cycle.

*To start soak with agitation, the Cycle Control Knob

must point to a number in the SOAK Cycle.

Cleaning the lint filter

Clean filter after every load for best

filtering results. Note: The load type
will vary the amount of lint build-up.

To clean:
• Lift offthe agitator barrel.
• Wash or wipe the filter clean in the

bottom of the agitator barrel. The

filter is not removable.

• Replace the agitator barrel and

snap into place.