Operating your dehumidifier – Whirlpool AD050 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING YOUR DEHUMIDIFIER
Operating your dehumidifier
Control panel
These units have a control panel containing
two controls-the PAN FULL Light and the
Humidistat.
PAN FULL Light-This light glows when the
water pan is full and needs to be emptied.
Humidistat-This controls the amount of
moisture in the room. When the humidity in
the room rises above the setting, the unit
automatically starts. When the humidity
drops below the setting, the unit automati
cally stops. The unit will run constantly when
the control is set to DRYEST.
Unit operation
1. Turn the Humidistat to OFF. Plug the
power supply cord into an electrical
outlet. Be sure to use the proper ground
ing method. (See page 6.)
2. Turn the Humidistat toward DRYEST for
normal operation.
The Humidistat can be set anywhere
between OFF and DRYEST. If you need
more dehumidification, turn the Humidis
tat toward DRYEST. If you need less
dehumidification, turn the Humidistat
toward OFF.
3. Turn the Humidistat to OFF to stop the
unit manually.