Whirlpool EVISOE - Manual (Page 4)

Check the strength of the floor It should hold the
weight of a fully loaded freezer
Pick a safe place, indoors, away from in­
flammables such as gasoline.
Allow 3 inches [ 7 5 cm] air space on top of freezer
for proper ventilation
Allow at leas' an inch (2,5 cm] between the
freezer condenser, on the back of the unit, and
the wall
Allow V, inch (1 25 cm) on each side of the freezer
for ease of installation
If the freezer is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
The four bolts that held your freezer in the shipping
crate are designed to be the levelling legs Screw
the legs far enough into the bolt holes, in each of
the four bottom corners, so the freezer stands
about 1 inch (2 5 cm] off the floor
Level freezer...
so the door wif stay
open at any position
Levelling Leg
Lower Raise
Start adjustment with the door hinge side.
1. Slide freezer into place.
2. Adjust front legs to level the freezer,
- To raise front, turn each leg in the direction
shown.
- To iower front, turn each leg in the direction
shown.
3. Check with level,
4. After freezer is fuiiy loaded, recheck with level.
Remove sales labels...
Remove the Consumer Buy Guide label and any
inside labels before using the freezer.
To remove any remaining giue:
1, Rub briskly with thumb to make a ball, then
remove
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] be­
fore removing glue as described in step 1.
DO NOT USE rubbing aicohol or flammabie or
toxic solvents, such as acetone, gasoline, car­
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet tas-
tened under the freezer at the front.
Plug it in...
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re­
quired It is recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep­
tacle which cannot be turned oft with a switch
or pull chain. See individual electrical require­
ments and grounding instruction sheet in your liter­
ature package.