Using your dishwasher, Before starting dishwasher, Starting dishwasher – Whirlpool WU685OV User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using Your Dishwasher
Models WU6850V (shown)
WU5650V
WU4406V
WU4400V
WU3006V
WU3000V
Before starting dishwasher
1. Read “Important Safety
Instructions" on page 2 before
starting your dishwasher.
2. Properly load the top and bottom
racks, and silverware basket. See
page 6.
3. Spin the upper and lower spray
arms to make sure nothing will stop
them from turning freely.
4. Add detergent.
5. Check rinse aid dispenser (models
WU4400V, WU4406V, WU5650V,
WU6850V only).
6. Push door firmly when closing and
it will automatically latch.
7. Run hot water at sink nearest
dishwasher until it is hot. Turn it
off.
Starting dishwasher
1. Select a drying option. (Select
ENERGY SAVER DRY for the Rinse
& Hold Cycle.)
2. Select any other desired options
that are available. Options may be
changed or cancelled by pushing
the Option Selector Button(s) again.
3. Turn Cycle Control Knob clockwise
to point to a desired cycle. You will
feel a definite stop at each cycle
mark. The dishwasher will
automatically start that cycle.
NOTE:
If the door is latched, you will
hear cycles start and stop as the knob
passes each cycle mark. This is normal
and will not hurt the dishwasher. If you
prefer, you can set cycles with the door
unlatched.
Removable pump guard
Filter screen
Continued on next page
Page 3