beautypg.com

Using your cooktop, Warning, Using the surface units – Whirlpool CEX215V User Manual

Page 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Using Your Cooktop

Models CEX650V (shown)
CEX630V (does not include grill or griddle)

Surface units

Grill (griddle module also included)

Control knobs

Control panel Model and serial number plate (under cooktop)

Model CEX310V

Surface units

Model and serial number plate
(under cooktop)

Control knobs

Control panel

Models CEX210V (shown), CEX200V &
CEX215V (with solid elements)

Surface units

Model and serial number plate

(under cooktop)

Control panel

Control knobs

Using the surface units

Control knobs must be pushed in
before turning them to a setting. They
can be set anywhere between HI and
OFF.

Surface unit indicators

The solid dot in the surface unit
indicator shows which surface unit is
turned on by that knob.

Signal lights

One of the Surface Unit Signal Lights on

the control panel wiU glow when a

surface unit is on.

A

warning

Burn And Fire Hazard

Be sure all control knobs are turned
to OFF and all signal lights are off
when you are not cooking.
Someone could be burned or a fire

could start if a surface unit is
accidentally left on.

Until you get used to the settings, use
the following as a guide. For best
results, start cooking at the high
settings, then turn the control knob
down to continue cooking.

Use a high setting to start food cooking;
to bring liquids to a boil.

Use a medium-high setting to hold a
rapid boil; to fry chicken or pancakes.

Use a medium setting for gravy,
puddings and icing; to cook large
amounts of vegetables.

Use a medium-low setting to keep food
cooking after starting it on a higher
setting.

Use a low setting to keep food warm
until ready to serve. Set the heat higher
or lower within the low band to keep
food at the temperature you want.

Solid element surface units

(Model CEX215V)

Before placing a pan on solid element
surface units for the first time, heat on
high setting for five minutes. The
surface units will give off smoke as the
protective coating, applied at the factory,
finishes bonding to the surface.

Continued on next page

Page 3

This manual is related to the following products: