beautypg.com

Installation requibements, Portable installation, Tools needed – Whirlpool 326035915 User Manual

Page 4: Permanent installation tools needed, Alternate parts, Installation requirements

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Assemble the necessary tools and supplies before beginning the
washer installation. The parts supplied are in the washer basket.

INSTALLATION REQUIBEMENTS

Parts supplied:

Portable Installation

Tools needed:

■ Pliers that open to 1®/i6" (3.95 cm)

■ Utility knife

■ Flashlight (optional)

Parts supplied:

A. Flat washars for faucet adapter and fill hose
B. Silver, double-wire hose clamp (for the bottom of the

drain hose)

C. Faucet adapter
D. Fill-and-drain hose

NOTE: To change a permanent installation to a portable
installation, a kit is required. To order, call the dealer from whom

you purchased your washer or refer to the “Assistance or
Service” section of this manual. Ask for Part Number 3935674.

Permanent Installation

Tools needed:

■ Pliers that open to 1®/i6" (3.95 cm)

■ Flashlight (optional)

■ Adjustable or open end wrench ®/ie" (14 mm)

■ Level

■ Wood block

■ Utility knife

■ Measuring tape

E

F

A. Drain hose
B. Silver, double-wire hose clamp

(for the bottom of the drain hose)

C. Yellow, single-wire hose clamp

(for the top of the drain hose)

D. Water inlet hoses (2)

E. Flat water inlet hose

washers (4)

F. Beaded tie strap

NOTE: To change a portable installation to a permanent
installation, a kit is required. To order, call the dealer from whom

you purchased your washer or refer to the “Assistance or
Service” section of this manual. Ask for Part Number 4396746.

Alternate Parts
Your installation may require additional parts. For ordering

information, please refer to the “Assistance or Service” section of

this manual.

If You Have:

You Will Need to Buy:

Laundry tub or
standpipe talier

than 72" (183 cm)

Sump pump system (if not already
available)

1" (2.5 cm)
diameter
standpipe

2" (5 cm) diameter to 1" (2.5 cm)
diameter standpipe adapter, Part No.
3363920

Overhead sewer

Standard 20 gal. (76 L) 39" (99 cm) tall
drain tub or utility sink, sump pump and
connectors (available from local
plumbing suppliers)

Floor drain

Siphon break. Part Number 285320;
additional drain hose, Part Number
3357090 and connector kit,
Part Number 285442

Water faucets
beyond reach of
fill hoses

2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,

10 ft (3.0 m) Part Number 350008

Drain hose too
short

Drain hose. Part No. 388423 and hose
kit. Part No. 285442

Drain hose that is

too long

Flose kit. Part No. 285442

Lint clogged drain

Drain protector, Part No. 367031