Whirlpool RT22AK - Manual (Page 5)

Before Using Your
Refrigerator
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it, arni level it.
Cleaning your refrigerator
Removing packaging materiais
ReoK>ve tape arnl any inside labels (except
the rrxxJel and serial number label) before
using the refrigerator.
To remove any remaining giue:
• Rub briskly with your thumb to make a ball,
then remove.
OR
• Soak area with liquid hand-dishwashing
detergent before removing glue as de­
scribed above. Do not use sharp instru­
ments, rubbing alcohol, flammable fluids,
or abrasive cleaners. These can damage
the material. See "Important Safety
Instructions” on page 3.
NOTE: Do not remove any permanent
instruction labels inside your refrigerator. Do
not rerrK>ve the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging materials,
clean your refrigerator before using it, if
necessary. See cleaning instructions on
pages 16 and 17.
Plugging it in
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a swKch or pull chain. Do
not use an extension cord.
See Electrical Requirements and Grourxl-
ing Instructions Sheet in your Literature
Package.
3-prong grounding
type wall receptacle
Refrigerator
power cord
3-prong
grounding plug