Whirlpool WSR413YW0 - Manual (Page 17)

Performance Data Sheet This Reverse Osmosis System has been tested and listed by NSF International
under Standard 58 for the water treatment claims listed below under
"Contaminant Reduction Performance”.
Whirlpool Reverse Osmosis Water Filtration System IV
Model No. WSR413YW
Contaminant
Reduction
Performance"
Influent
(ave. mg/L)
Effluent
(ave. mg/L)
Effluent
(max. mg/L)
Min.
% Rej.
EPA'
MCL
Arsenic 0.28 0.029 0.05 90% 0.05
Barium^ 10.0 0.01 0.03 99% 2.0
Cadmium^ 0.032 0.0001 0.0004 99% 0.005
Chromium
(Hexavalent)^ 0.16 0.006 0.02 96% 0.1
Chromium
(Trivalent)^ 0.14 0.002 0.002 99% 0.1
Fluoride 8.8 0.26 0.37 97% 4.0
Lead 0.22 0.002 0.008 99% 0.015
Mercury 0.0054 0.0005 0.0016 91% 0.002
Nitrate 29.0 1.69 4.6 94% 10
Radium 226/228^ 25 piC/L 5 piC/L 5 piC/L 80% 5 piC/L
Selenium 0.098 0.001 0.007 99% 0.05
Test Parameters
TDS = 200-500 mg/L^ pH = 7.5 Turbidity = 1 NTU Temperature = 77°F Pressure = 50 psig
’USEPA Maximum Contaminant Level or Action Level (mg/L).
^Barrium, Cadmium aiid Chromium were tested at 750 mg/L TDS.
^The reduction of Radium was verified by using Barium as a surrogate under NSF protocol.
^These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
In addition to the contaminants listed above, these systems also have the ability to effectively reduce non health-related chemicals
like Chlorides, Phosphate, Sodium and Sulfates.
APPLICATION GUIDELINES/SPECIFICATIONS AND FEATURES
Membrane Type TFCM Water Supply Parameters
Water Supply-Community
or Private Well
Chlorinated
Only
Chemical
Hardness Limit
<350 mg/L
Water Pressure 40-100 psi (3-7 Kg/cm^) Iron <0.1 mg/L
Water Temperature 40°-100°F (4.4-38°C) Manganese <0.05 mg/L
pH Range 4-11 Hydrogen Sulfide 0
Maximum TDS Level 2000 ppm Turbidity <1 NTU
CAUTION: Do Not use where water is microbiologically unsafe or with water of unknown quality.
Water supplies that exceed limits for Hardness, Iron, Manganese, Hydrogen Sulfide require pretreatment.
Important Quality Assurance Requirements
This Reverse Osmosis Drinking Water system contains treatment components that are
critical for effective reduction of Total Dissolved Solids as well as inorganic contaminants.
A water quality monitor (indicator light disk) is build into the system to provide the user with a
means to test the water at any time. Refer to "Use and Care Information” for operation of the
water quality monitor (indicator light disk).
Routine Maintenance
Sediment Prefilter, Carbon Prefilter and Carbon Postfilter: Change once per year*
Membrane: Change as required based on the built-in water quality monitor.
’Refer to "Use and Care Information” for additional conditions.
Purification Assembly Components
Sediment Prefilter: 5 micron Nominal Depth
Cartridge
Carbon Prefilter: Activated Carbon
Membrane Type: Thin Film Composite (TFCM)
Carbon Postfilter: Activated Carbon
General Performance
Testing Laboratory*
System Production: 10.3 gal/day (39 liters/day)
Minimum TDS Reduction: 96%
’Rated at 50 psi, 77°F, 750 mg/L NaCI, product to storage tank.
Standard Tank Capacity: 2.6 Gallons maximum.
Factory sanitized and ready to install.
Reject Water: This drinking water appliance has a
self cleaning feature that requires approximately
3 gallons of rinse water for every gallon of high
quality water used.
Factory Specifications**
Membrane Production:
14-20 gal/day High-
Flow Membrane
Membrane TDS Reduction: 96% Minimum
’’Rated at 60 psi, 77®F, 350+ mg/L TDS, product to atmosphere.
Note: Actual production rate and TDS reduction will depend
upon temperature, water pressure, TDS level, membrane
variation and usage pattern.
All Drinking Water Appliances are factory tested, sanitized and prepared for installation.
WARRANTY
Length of Warranty: Whirlpool will pay for:
One Year Full Warranty
(from date of purchase) Replacement parts and repair labor to correct defects
in materials or workmanship for the entire product
except for the filter cartridge(s). Servicing must be
provided by an authorized Whirlpool servicing outlet.
Five Year Limited Warranty
(second through fifth year
from date of purchase)
Replacement parts to correct defects in materials or
workmanship tor the entire product except for the
filter cartridge(s).
Whirlpool will not pay for:
A. Service calls to:
1. ) Correct the installation of the product. System must be installed and operated in accor­
dance with Whirlpool procedures and guidelines.
2. ) Instruct you how to use the product.
3. ) Correct house plumbing.
B. Repairs when product is used in other than normal, single-family household use.
C. Repairs when product is damaged from neglect, misuse, abuse, freezing or hot water, fouling
with sediment or scale, bacterial attack, alterations, improper installation, or installation not in
accordance with local plumbing codes.
D. Any labor costs during the limited warranty.
E. Replacement parts or repair labor costs for units operated outside the U.S.
F. Pickup and delivery. This product is designed to be repaired in the home.
G. Repairs to parts or systems caused by unauthorized modifications made to the product.
The performance and functioning of your water filtration system is directly related to the quality of
the water being treated and the particular application in which it is used. Please consult "Water
Requirements” and "Use & Care”.
Whirlpool shall not be liable for Incidental or consequential damages. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so this limitation or exclusion may
not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
17