Now start installation, A. install ventwork – Whirlpool 4LEC7646EN0 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Now start installation

(If installing washer and dryer, install dryer first.)

See installation steps for details.

Check operation.

SLIDE DRYER ONTO
CARDBOARD OR
HARDBOARD BEFORE
MOVING ACROSS TO
PREVENT FLOOR

DAMAGE.

A. Install ventwork

Put on safety glasses and gloves.

Install exhaust

hood. Use caulking
compound to seal exterior

wall opening around
exhaust hood.

Connect exhaust vent to hood. (Exhaust

vent MUST fit inside hood.) Secure vent to hood
with vent tape.

■ Run exhaust vent to dryer location. Use

the straightest path possible. Avoid 90° turns.

Use vent tape to seal all joints.

Remove tape from dryer cabinet.

Open dryer door and remove tape from dryer
drum. (Not all dryer drums are taped.) Remove
drying rack, if included. Turn dryer drum
counterclockwise to make sure all tape was
removed. Wipe drum with damp cloth to
remove any dust.

diamond
marking

■ ■ Take two cardboard corners from dryer

carton and place them on floor in back of dryer.
Firmly grasp body of dryer and gently lay it on
its back on the cardboard corners.

Start to screw legs into holes by hand.

Use an adjustable wrench or 1" hex-head
socket wrench to finish turning legs until you
reach the ridge with the diamond marking.

■ Stand dryer up on cardboard

or hardboard.

PanelC