The key eject lock, Freezer shelves, Bottom trivet – Whirlpool EV150NXK User Manual

Page 4: Changing light bulb, To remove base grille, To replace base grille

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

The Key Eject Lock...

can help r e d u c e t h e hazard of child

entrapment.

To lock or unlock the freezer you must hold the

key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.

If the key is lost, contact your WHIRLPOOL dealer

for a replacement. Always give the complete
model and serial number of your freezer when
requesting a replacement key.

Freezer Shelves...

To remove:

Lift front slightly, then lift shelf from back supports.

To replace:

Set back of shelf on rear supports then lower

the front on to front mounts.

Bottom Trivet...

To remove:

To replace:

• Lift up, then pull out. • Set In bottom ot freezer.

• Push into place.

Changing Light Bulb.

1. Unplug power cord.

2. Rem::>ve light shield by pulling away from the

side wall.

3. Replace bulb with 40 watt appliance bulb.

4. To replace shield, insert tabs into slots in wall

and press.

To Remove Base Grille...

• Open the door.
• Pull grille outwards as shown.

To Replace Base Grille..

METAL CLIPS

SUPPORT TABS

• Line up grille support tabs with metal clips.
• Push fii miy to snap into place.
• Close the door.

• Do not remove Tech Sheet fastened behind

the gri le.