Install properly, Level freezer, Remove sales labels – Whirlpool EV150NXK User Manual
Page 2: Clean it, Plug it in, Before you plug it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Before you plug it in
Before using your freezer, you are personally
responsible for making sure thaf It...
• Is installed and leveled on a floor that will
hold the weight, and in an area suitabie for
its size and use.
• is conneoted only to the right kind of outlet,
with
the
right
electrical
supply
and
grounding.
• is used only for jobs expected ot home
treezers.
• Is not near an oven, radiator or other heat
source
• is properly maintained.
• is in Cl dry sheltered place.
• is used in an area where the room tempera
ture will not exceed 110“F (43.3“C).
• is not run where there are explosive fumes.
• is not used by children or others who may not
understand how it should be used.
• is not loaded with food before it has time to
get properly cold.
Install Properly...
1. Check the strength of the floor. It should hold
the weight of fully loaded freezer.
2. Pick a safe place, indoors, away from in
flammables such as gasoline.
3. Freezer may be Installed flush against wall
in back. Allow V
2
inch (1.25 cm) on each side
of cabinet.
Level Freezer...
so that door will stay open at any position.
1. Remove base grille (see page 4
2. Starting with door hinge side,
turn left to raise corner.
3. Turn right to lower corner.
4. Check with level.
5. After freezer is loaded with
food, recheck with level.
o
Raise Lower
Remove Sales Labels...
Remove the Consumer Buy Guide label and
any inside labels before using the freezer. Re
move any left over glue with rubbing alcohol.
Note: DO NOT REMOVE the Tech Sheet fas
tened behind the base grille.
Clean It...
Clecn your freezer before using it. See clean
ing instructions on page 5.
Plug it in...
Recommended Grounding Method
Aii^Li Volt, 60 Hz., AC only, 15 or 20 ampere fused
electrical supply is required. It is recommended
that a separate circuit serving only this appliance
be provided. The receptacle should not be con
trolled by a wall switch or pull chain.
Do not use an extension cord.
See individual electrical requirements and
grounding instruction sheet in your literature
package.