For a rinse and spin, For a soak or pre-wash, Cleaning the lint filter – Whirlpool LT5000XL User Manual

Page 10: Other operating instructions, For a drain and spin

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Other operating instructions

For a drain and spin

Your washer can be set to drain

and spin cutwater.
• Push Control Knob in.
• Turn clockwise to the bar just before

OFF. See above drawing.

• Pull Control Knob out.
• The washer will drain and spin.

For a rinse and spin

You may need an extra rinse and

spin for heavily soiled loads which
need more detergenf. (Extra de
tergent can require an extra rinse.)
• Push Control Knob in.
• Turn clockwise to any • on the dial.

See above drawing.

• Pull Control Knob out.
• The washer will fill to selected level

with cold water, agitate 2 minutes,
drain and spin.

For agitation and spin speeds in each cycle, see pages 8 and 9.

For a soak or pre-wash

For best results, use warm water • Use enough detergent or pre-soak

for soaking or pre-washing soiled product for a single load,

laundry.

• Push Control Knob in.

* Turn clockwise to point at a number

in the SOAK Cycle.

* Pull Control Knob out.
» When the cycle is over, add de

tergent for the next selected wash
cycle. Important: See additional
care information on page 7 of your
“Laundry Guide.”

* Set the washer and start the next

selected wash cycle.

To start the soak or pre-wash with agitation, the Cycle Control

Knob must point to a number in the SOAK Cycle.

Cleaning the lint filter

Water runs through the lint filter

whenever the washer agitates.
Check it often to make sure it's clean
and is filtering at its best.

To remove it for cleaning, press the

release and pull straight out. Instruc

tions for cleaning are printed on the

bottom of the filter.