Whirlpool EV160EXK - Manual (Page 3)

Setting the Cold Control...
To start, turn control to the middle of the dial.
This setting will maintain zero zone temperatures
under normal operating conditions.
Using your freezer
Note: When freezer is first started the compressor
will run constantly until the cabinet is cooled. It
may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times
the freezer door is opened.
After t ie cabinet is cooled the compressor will
turn on and off as needed to keep freezer at
proper temperature.
7\\
POWER SAVING CONTROL
REDUCES
i
I HU I ►
EXTERIOR
OFF ON
SAVES
POWER
MOISTURE
Adjusting Cold Control...
• Turn control to higher number for colder
temperatures.
• Turn to lowernumber for less cold temperatures.
Cooling Freezer First...
• Allow freezer to cool 6 to 8 hours before filling
with frozen food.
• Let it cool overnight before adding large
amounts of unfrozen food.
• Frost will form on the shelves. It will form first and
be heavier on the top shelves.
The Power Saving Control...
operates electric heaters. These heaters help
prevent moisture from forming on the outside of
the freezer when humidity is high.
• Use the OFF setting when humidity is low to save
electricity.
• Use ON only if moisture forms on outside of
freezer.
Exterior Signal Light...
automatically warns of any unexpected power
failure.
Signal light
If the signal light is not glowing, immediately
check:
• for power interruption,
• the power cord; it may be disconnected from
the outlet,
• the signal light; it may be burned out.
To replace burned ouf signal lighf:
1. Unplug power cord from outlet.
2. Remove bdse grille. See page 4.
3.
4.
5.
Unplug burned out light and replace with one
of same wattage and size. Signal light can be
ordered from your WFIIRLFOOL deoler. Part No.
530584.
Replace base grille. See page 4.
Plug power cord into outlet.