beautypg.com

Using the automatic ice maker – Whirlpool 8ET18NK User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Raise
signal
arm to
stop ice.

Lower

signal
arm to
start it.

Using the automatic ice maker

(Factory-installed on ET18NM and ET20NM,
optional on ET18IMK and ET20NK)

If you have an automatic ice maker, or if you plan

to add one later (Part No. ECKMF-90), there are

a few things you will want to know:
• The ON/OFF lever is a wire signal arm.

Down ... to make ice automatically.
Up ... to shut off the ice maker.

NOTE: Do not turn ice maker on until it is
connected to the water supply. Instructions for
ice maker water supply hook up are at­
tached to the back of the refrigerator

cabinet.

• The dial or lever on the side of the ice maker

changes the size of the cubes.

• Shake the bin occasionally to keep cubes

separated and to obtain increased storage
capacity.

• It is normal for ice crescents to be attached by

a corner. They will break apart easily.

• You will hear water running when ice maker is

working. You’ll hear ice fall into the bin. Don’t

let these sounds bother you.

• The ice maker will not operate until the freezer

is cold enough to make ice. This can take
overnight.

• Because of new plumbing connections, the first

ice may be discolored or off-flavored. Discard

the first few batches of ice.

• If ice is not being made fast enough and more

ice is needed, turn the Refrigerator Control

toward a higher number. Wait a day and, if

necessary, turn the Freezer Control toward A.

• If you remove the ice bin, raise the signal arm

to shut off the ice maker. When you return the

bin, push it in all the way and lower the signal
arm to the ON position.

• If cubes are stored too long, they may develop

an off-flavor... like stale water. Throw them
away. Ice maker will make new ice. Cubes in

the ice bin can also become smaller by
evaporation.

• Good water quality is important for good ice

quality. It is not recommended that the ice
maker be connected to a softened water
supply. Water softener chemicals, such as salt
from a malfunctioning softener, can damage the

ice maker mold and lead to poor ice quality. If a
softened water supply cannot be avoided, it is
important that the water softener be well
maintained and operating properly.

This manual is related to the following products: