Whirlpool 8ET18NK - Manual (Page 11)

Removing the crisper cover
ET18NK and ET18NM
To remove the cover:
1. Remove the chspers.
2. Lift cover front.
3. Pull cover up and out.
To replace the cover:
1. Fit back of cover into notch supports on walls
of refrigerator.
2. Lower front into place.
3. Replace chspers.
ET20NK and ET20NM
To remove the cover:
1. Push up glass insert from the bottom, then
slide it out with both hands.
2. Lift front of cover frame.
3. Pull cover frame up and out.
4. Remove metal cover support.
To replace the cover:
1. Replace metal cover support on wall supports
in front section of cabinet.
2. Fit back corner of cover frame into notch
supports on walls of refrigerator, then lower
front onto metal cover support.
3. Slide back of glass insert into cover frame.
Then lower front to level position.
Remove the
glass insert.
Lift front of
cover frame,
then the back.
Using the ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation. The
longer cubes are stored, the smaller they get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
dqce
™
10