Pre-wash cycle, Cleaning the lint filter, To clean – Whirlpool LT51OOXS User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Pre-wash cycle

For best results, use warm water for

pre-washing stained laundry. Hot water
can set stains.
1. Use recommended amount of

pre-soak product or detergent.

2. Push Cycle Control Knob in.
3. Turn clockwise to point to the

number next to PRE-WASH.

Pull the Cycle Control Knob out. The

washer will start.

5. When the cycle is over, add

detergent for the next selected wash
cycle. The PRE-WASH Cycle should
always be followed by a wash cycle.

NOTE:

See the Laundry Guide for

additional pre-washing information.

Agitator
barrel

Lint filter

Cleaning the lint filter

Clean the filter after every load for the
best filtering results.

NOTE:

The load type will vary the

amount of lint build-up.

To clean;

1. Lift off the agitator barrel.

2. Wash or wipe the filter clean in the

bottom of the agitator barrel. The
filter is not removable.

3. Replace the agitator barrel and snap

it into place.

This manual is related to the following products: